Schwintek Slide Problem
On a routine check of my RV, the slide won't go out. It is the Schwintek type slide. I have already read through all the manual & bulletins and watched their youtube videos. I have tried everything th...
Forum Discussion
lightfoot wrote:
BayouBoys- I had almost the same problem with one of mine. It was stuck in and only one side would move an inch or two and then stop. Had to take it to the dealer. As you know that screw that holds the motors onto the drive shaft is located outside the trailer and always inaccessible if the slide is stuck in. The dealer had to remove the outside framework of the slide to get at the screws for the motors and then was able to get the slide out.
Turns out that one of the motors got water in it and rusted the shaft which stopped it from turning. Also, the new motors are a 50:1 ratio not vs. the original 30:1 ratio.
If the dealer gets yours working, make sure they get the updated motors. The slide will go in and out slower, but at least it should work.
Yep, I think that is exactly it. From the inside I can see where the motor is rusted. I have given up, off to the dealer. Wish me luck, last time i brought it in they kept it for 4mo. and had to call every day to get the work completed.
Thanks to all.
