Size and thread pitch of Honda eu2000i oil fill
Does anybody know the size and thread pitch of the Honda eu2000i oil fill cap? I'm thinking about trying to make a remote funnel that screws into the hole. Thanks
Forum Discussion
Thanks all, I appreciate the suggestions. :) Yes I've seen the one on Amazon, it's what got me to thinking about this.
I guess I should have stated this a different way.
I have a 3d printer and I wanted to try to make and improve on the idea from Amazon. No I'm not planning to make and sell, this is just for my own use. I can do the trial and error route, but I was hoping someone might have the answer before I did that.
Anyway I'll probably just try to print a few size tubes and thread pitches and see what I can come up with.
Thanks
I guess I should have stated this a different way.
I have a 3d printer and I wanted to try to make and improve on the idea from Amazon. No I'm not planning to make and sell, this is just for my own use. I can do the trial and error route, but I was hoping someone might have the answer before I did that.
Anyway I'll probably just try to print a few size tubes and thread pitches and see what I can come up with.
Thanks
