Slide out will not retract
Our slide out will extend every time we go but it will not retract. It starts to retract maybe an inch and then stops. It is a mechanical slide out. We have a 30 ft. Terry Dakota with a 12 ft slide....
Forum Discussion
I have a few switches that are kind of flakey, if you don't press 'em just so they don't activate... However there are other causes of that same issue epically with current sense controllers like Power gear and Accuslide.. IF for any reason the current increases in the motor STOP
My problem was a slide that would not move at all. I mean it just did not even try... All last night.. This morning.. "Shot" right out when I gave it one last try before calling for hepl, er, help. Theory I have (Not the slide's fault, heat from Generator (Next to slide motor) was enough to make Thermal Protection engage and it took that long to cool off.. I know it takes a LONG time for the gnerator to cool off from when I changed the oil.. 4 hours and it was still warm.
But.. I'm worked.. Anyone know where Damon hid the controller on a 2005 Intruder 377@W?
My problem was a slide that would not move at all. I mean it just did not even try... All last night.. This morning.. "Shot" right out when I gave it one last try before calling for hepl, er, help. Theory I have (Not the slide's fault, heat from Generator (Next to slide motor) was enough to make Thermal Protection engage and it took that long to cool off.. I know it takes a LONG time for the gnerator to cool off from when I changed the oil.. 4 hours and it was still warm.
But.. I'm worked.. Anyone know where Damon hid the controller on a 2005 Intruder 377@W?
