Tekonsha constant duty isolator
I have searched the internet for hours and can not find the AMP draw on the coil to activate the relay. I would like to put a fuse between the Ignition point and the trigger side of the relay, just f...
Forum Discussion
Suggest you measure the current draw
As Fred said a 5amp fuse should be good
From what I have seen the coil current varies quite a lot between different manufacturers and models. Seen some as high as a few amps and some less than a 1/2 amp. I assume yours is a 100% Duty Cycle Solenoid. Some run hot to the touch and some cool.
Sounds like Fred got a good one
I found these folks to have good quality and a great price
http://www.dbelectrical.com/
As Fred said a 5amp fuse should be good
From what I have seen the coil current varies quite a lot between different manufacturers and models. Seen some as high as a few amps and some less than a 1/2 amp. I assume yours is a 100% Duty Cycle Solenoid. Some run hot to the touch and some cool.
Sounds like Fred got a good one
I found these folks to have good quality and a great price
http://www.dbelectrical.com/
