Top of Slideout Not Fully Retracting
I have a side slideout that the top is not fully retracting in an Eagle Cap 1160. The bottom of the slideout is making good contact with the outside seal, however the top of the slideout needs to come in an additional 1/2" - 3/4".
It seems to move normal with no unusual binding or issues, the top just fails to come in all the way. It does have a topper. If I get on a ladder and manually turn (with minimal effort) the slideout topper, the top of the slideout closes the gap to the camper.
Gear tracks on the bottom look ok, nothing on the top of the slideout, and no obvious impediments. For good measure I cleaned and waxed the sides of the slideouts which did increase the speed, but no affect on the retraction issue.
This is a Powergear style slideout with motor on the bottom back and two gear track rails with bar connecting rear track to the front.
Thanks in advance for any ideas!
It seems to move normal with no unusual binding or issues, the top just fails to come in all the way. It does have a topper. If I get on a ladder and manually turn (with minimal effort) the slideout topper, the top of the slideout closes the gap to the camper.
Gear tracks on the bottom look ok, nothing on the top of the slideout, and no obvious impediments. For good measure I cleaned and waxed the sides of the slideouts which did increase the speed, but no affect on the retraction issue.
This is a Powergear style slideout with motor on the bottom back and two gear track rails with bar connecting rear track to the front.
Thanks in advance for any ideas!
