What tool to remove fresh water fill collar to replace hose?

‘‘Tis the season” so to speak........

Thx for all the help and advice. It did not look like I could easily get to the clamp at the water fill. Turns out the van has a few issues and I've elected to hire a mobile RV repairman. It is crazy here in the Phoenix area to get anything fixed in less than a month.

^^^^I had to use that driver to change my turn signal fluid^^^^^^????

Unclamp the hose at the tank
Than pull everything including hose out,
May have to unclamp house at back of fill,
Depends on how big of hole is in the wall

You do not take that apart, unless you drill out the rivets
It was not mfg to come apart, and not install in pieces

Are you sure you want to drill out those pop rivets? Seems to me the hose you want to replace should be clamped to that water inlet. Look around for access to the back of that inlet and you might see a hose clamp to remove.

Those requite a #7 double reversed schwansoculator driver.

Those are however really hard to find, a 1/8" or slightly larger drill bit will substitute nicely.

Those do not look like screws (But detail is not that good) they look like POP rivets. you drill those to remove.

X4 on the drill and pop rivit.

Dan

A drill, those are pop rivets.

Moved to Tech Issues forum from DIY.