Xantrex prosine 2.0 problem. Again
It's not passing the shore power (or Gen power) through to the rig. There are no error codes or messages. It is in line with ONE leg of our 50Amp service. We are plugged into a 30Amp outlet. We hav...
Forum Discussion
liborko wrote:
I suspect voltage or frequency is out of acceptable range of Prosine so it does not pass it thru. The voltage and frequency range is programable by a remote control panel-operation manual is needed to reprogram.
Have that happen often with the poor voltage regulation down here--too high at night and too low during the day but that is not the problem this time. I get the same result with the generator running.
