Xantrex prosine 2.0 problem. Again
It's not passing the shore power (or Gen power) through to the rig. There are no error codes or messages. It is in line with ONE leg of our 50Amp service. We are plugged into a 30Amp outlet. We hav...
Forum Discussion
petrel wrote:
I went through the same issue with the same unit before. Did the resets and everything. I am embarrassed to say that in our case it was just one of the pop out breaker on the side of the Xantrex unit itself. Pressed it in and we had power again.
Looking at the Prosine 2.0 I cannot see any pop out breaker anywhere. I can only access the AC and part of the side nearest the AC connections without pulling the unit. It's in a tight spot. I cannot find any mention of breakers in the manual.
