Xantrex prosine 2.0 problem. Again
It's not passing the shore power (or Gen power) through to the rig. There are no error codes or messages. It is in line with ONE leg of our 50Amp service. We are plugged into a 30Amp outlet. We hav...
Forum Discussion
2oldman wrote:
I was going to suspect a blown xfer switch, but if the remote says no ac... that doesn't quite work.
The main transfer switch is ahead of the Prosine 2.0, from the shore power and the generator. I have the same problem with either shore power or generator. Beginning to think that too. I'll start tracing the voltage when the downpour stops.
