Brake Assembly Installation
Over a year ago I removed and replaced, with new, the four brake assemblies on our two axle travel trailer (unbolted the entire assembly from the axle). I also installed new bearings, races, seals etc...
Forum Discussion
You need to remove the bearings and clean them completely, then inspect them for any issues. I have had the cheap Chinese bearings fail in one long trip. Also the shoulder that locates the inside bearing is pretty much nonexistent allowing increased clearance in short order, despite the naysayers that counter that fact. The cap coming off may have been distorted too much when you installed it, or maybe when it was payed off. Clean things up, take photos and let’s see if we can get this resolved.
