Camper sold... should I remove the Tork Lift barckets?

Why did I not think of this?!! Thanks for that I’m stealing that idea!
I have running boards but the rear could use those!

Ours used the fishing wire to place 2 bolts, however I do not remember once in place what was involved as far as tightening and getting wrench on it (so what would take to get back off). Worst case is cut/grind off.

Curious, actually I just looked, Id try to unbolt but at least 1 and assume the other also is a carriage bolt (probably why I don't remember getting a wrench on it), likely it or frame would yield/spin so cut off wheel (or nut splitter) would be handy and probably easiest from the get-go.
However given age and limited range of trucks they would fit I doubt worth the effort. The fronts I think on yours may fit up to an '09 but part number would help to sell for fit. But for 5 year range I wouldn't bother. Might be a plus when if selling truck.
The Fastguns easily re-sell.
Another suggestion is re-purposing the front mounts and arms. I welded plates on top of insert arms and use as bed access steps when camper not loaded. I reworked some old arms but could be done and still use as camper mounts.

I use mine alot for getting in or just standing to reach bed floor.

I don't remember if getting the front mounts off and re-installed would be impractical. If not, I'd totally take them off and put on Craigslist. Popular model truck, they should sell quick.

If you think you might get another TC and haul it on that same truck, I would just leave them on. Otherwise, I would put them on ebay and if they sell, pull them off and ship them off.

I've just removed the oem hitch on our 2018 F350 and replaced it with a 30k Torklift hitch and 4' extension. I'm already planning for swapping it all back and selling the Torklift stuff many years down the road.