Cleaning up rear rotted 'skirts' on camper...
Literally Drivers side 06/08/14 Passenger Side 07/23/14 Last thing yesterday, swept up our rear driver side skirt or rear wing. After putting it off for way too long- forced to start the...
Forum Discussion
It'll be a slow process. Mostly cause I really dont want to do it so draggin my feets. But I did pick up sheet of plywood. I had hoped to rough cut drivers side tonight so I could laminate the luan to one side and allow to set for awhile before cutting. But when I pulled out of truck and set on table its curled, warped and twisted. Laying flat its 3/16" in 24" in any direction.
Never seen a piece of 3/4" so bad. If I didnt know better Id say its been edge standing for a while. Oh well, try again tommorrow, and self pick & load.
96 probably wood frame I believe. Simular construction just different obstacles I would think. There are some good threads in the TCU.
Never seen a piece of 3/4" so bad. If I didnt know better Id say its been edge standing for a while. Oh well, try again tommorrow, and self pick & load.
96 probably wood frame I believe. Simular construction just different obstacles I would think. There are some good threads in the TCU.
