Crown Designed Into Chev and GMC Truck Beds
HI Folks: I just came away from the Towing Forum and found out that Chev and GMC Trucks have been designed to have a crown designed into their truck beds (truck bed is not flat lengthwise). Link http...
Forum Discussion
My "fix" for this was a piece of rubber 3/16" thick measuring 12"x48" placed crossways at each end, under my horse mats. It trued up the mats and using a long level showed only about 1/8" gap at mid way between the crowned point and the front or rear of the bed mat. With compression, I'm convinced that gap goes away when the camper is loaded. Road test over a known bumpy section, showed no perceptible reduction in porposing, but for $40, it makes me feel better. YMMV.
