this year we purchased and 2016 Outback model OB326RL 16. The booth is suppose to make into a bed but none of the cushions fit in any configuration to cover the entire bed area. The back cushions will not fit at all to make up the space left by the lowered table. Has anyone else had this problem?

Cushions too tight or not big enough? I don't have an Outback, but my dinette cushions have to be forced into place

Interestingly, in the 2+ years I've owned this TT, I haven't tried the conversion yet, because I haven't needed to. I did it many times in my previous TT with no issues at all.Do you have a straight dinette, or a U-shaped dinette?

My cushions are tight and have to be forced in, just as Pira stated. I would rather have this than loose cushions that leave gaps. I do not have an Outback.

Doug33 wrote:Interestingly, in the 2+ years I've owned this TT, I haven't tried the conversion yet, because I haven't needed to. I did it many times in my previous TT with no issues at all.Do you have a straight dinette, or a U-shaped dinette?Without lowering the top you could measure the back cushions and see if they match the table width.

IN my wrap around seating on my OFF-ROAD POPUP I have to use the correct sized cushions in the right place to get them to fill the empty spaces correctly...Since my setup is a wrap around I have one large cushion that is not part of the seat cushions to use as well. It perfectly fits over the top of one of the storage cabinet tops.I had no idea what the extra cushion was for until I setup the bed the first time...Roy Ken

dining booth to bed woes | Good Sam Community

korbe
Explorer
Sep 23, 2015
Doug33 wrote:
Interestingly, in the 2+ years I've owned this TT, I haven't tried the conversion yet, because I haven't needed to. I did it many times in my previous TT with no issues at all.

Do you have a straight dinette, or a U-shaped dinette?

Without lowering the top you could measure the back cushions and see if they match the table width.
Alabama_Jim
Explorer
Sep 23, 2015
My cushions are tight and have to be forced in, just as Pira stated. I would rather have this than loose cushions that leave gaps. I do not have an Outback.
Doug33
Explorer
Sep 23, 2015
Interestingly, in the 2+ years I've owned this TT, I haven't tried the conversion yet, because I haven't needed to. I did it many times in my previous TT with no issues at all.

Do you have a straight dinette, or a U-shaped dinette?
pira114
Explorer II
Sep 23, 2015
Cushions too tight or not big enough? I don't have an Outback, but my dinette cushions have to be forced into place

Forum Discussion

dining booth to bed woes

About Travel Trailer Group

Related Content

Change dining booth to table and chairs

Roadside assistance woes!

Luan woes

SEVERLY wobbly dining table

Dometic fridge woes.