Fuse for Camper Jacks - field help please.

Question

I have a Lance 1010 and we are camping right now - I've run into a problem. when I hit the floor button for the Camper Jacks, the red light doesn't go on and the remote does not work. I've read the fuse box and owners manual and no mention of a fuse. any ideas - we usually lower the jacks to stabilize the camper, but this May not happen on this trip unless y'all have some guidance

I HOPE EVERYONE HAD A GREAT THANKSGIVING.

bedlam · Answer

Check if you have dedicated fused lead off the battery for supply voltage. In my Arctic Fox, the controller sits under the sink. You can check the remaining fuses at the controller.

anev942 · Answer

?http://www.lancecamper.com/owner-support/Not sure, Lance changed links-almost looks like pdfs are a year off clicking 2010 brings uphttp://www.lancecamper.com/docs/09-owner-manual.pdfhttp://www.lancecamper.com/docs/10-owner-manual.pdfBoth docs though say power receiver (with 4 fuses / jacks with remote) should be in forward  most cabinet drivers side (usually in cabover step up box)Got manual handle?

wheelholder · Answer

If you cannot find the fuse, do you have the hand crank?  That would solve the problem temporarily.

yosemiteford · Answer

Wheelholder wrote:If you cannot find the fuse, do you have the hand crank?  That would solve the problem temporarily.we ended removing the cover for each jack and with a 12 volt battery retracted the pole on each jack.  thank goodness much easier than the hand crank.  we bypassed the switch.

gripnriprod · Answer

Great temporary solution!  Hope your Thanksgivinng was great!  Ours was, thanks! Sounds like you have a common source problem since none of the four legs would run.  Not sure how the Lance is wired or the location of the controller.  Best wishes.

Forum Discussion

Fuse for Camper Jacks - field help please.

5 Replies

About Travel Trailer Group

Related Content

Camper Jack

Truck camper match

New Truck Camper Forum Comments

Truck Camper Jacks

Truck Camper Tie Downs