Forum Discussion

The_Mad_Norsky's avatar
The_Mad_Norsky
Explorer
Jan 27, 2015

Help! Foolish me playing mechanically inclined again.

Tried, most correctly described, to put the upper overload Stableloads on my new truck today. Beautiful weather for it here. Well, to make this short, I cannot get one of the factory nuts off for ...
Truck Campers
time2roll's avatar
time2roll
Nomad
Jan 28, 2015
The Mad Norsky wrote:
Went and purchased a 15mm combination wrench. It would be correct size, and fit into the tight quarters where the nut is located.

And (another :S) the poor nut is too messed up for the wrench to grab. Mind you, it would grab if I were turning the other way and attempting to tighten. A lot of good knowing that.

Back to the drawing board.
Put the wrench on and get a couple pictures to post.

About Travel Trailer Group

44,052 PostsLatest Activity: Sep 11, 2014