"Poles on slide?" 1999 Jayco Eagle model 266

From the manual

2. For Eagle and Qwest models, remove “travel bars” (Fig. 3-5) from behind the
top facia board located above slideout room.
See page 23 in the link

Wife'nHubby wrote:
Thanks for the reply! I was able to find the manual online. My question has been answered.

What was the answer?!

Sharing is nice.

Thanks for the reply! I was able to find the manual online. My question has been answered.

Back in the late '90s, early 2000s, I remember shopping some trailers that had rear queen bed slides that required supports when deployed. In some cases they were brackets that folded out, in other cases they were poles that needed to be added. That's all I can think of. I haven't looked at the floor plan though.

But OP says..."Remove poles before cranking in."

We had a 99 243RKS 5'er, it had 2 bars that held the slide IN. They laid on top of the slide. We tie some red ribbon to them that hung down as a visible reminder to remove them before running the slide out.

See response to 5:13 post.