I'm not sure if I searched for the wrong subject, but I wasn't able to find anything there.I would like to know what, if anything, others have found to work as good weight distribution devices you use when supporting your campers on soft ground with the jack stands, to keep them from sinking in?Thanks again in advance!

I use about foot stall mat squares, but also squares of plywood work as well.

Lumber, plywood, those plastic leveling blocks, um that about covers it.

Thanks guys....simple....inexpensive.....my kind of solution!!

Lots of difference. How much weight? Will there be any movement? How soft is the ground? How long will it set, will water/plywood cause problems? Do you want the load to slip on the plate?Under the front jacks will running over the bases cause issues? If so, that plate must be larger to hold off-center load.

Recommended jack stand ground support plates. | Good Sam Community

Reality_Check
Nomad II
May 21, 2021
Grit dog wrote:
^Mole hill, meet mountain...lol

Refreshingly, Capt Obvious has arrived... lol
Grit_dog
Navigator
May 20, 2021
^Mole hill, meet mountain...lol
JRscooby
Explorer II
May 20, 2021
Lots of difference. How much weight? Will there be any movement? How soft is the ground? How long will it set, will water/plywood cause problems? Do you want the load to slip on the plate?
Under the front jacks will running over the bases cause issues? If so, that plate must be larger to hold off-center load.
mt-ed
Explorer
May 20, 2021
Thanks guys....simple....inexpensive.....my kind of solution!!
deltabravo
Nomad
May 20, 2021
Squares of plywood
Grit_dog
Navigator
May 20, 2021
Lumber, plywood, those plastic leveling blocks, um that about covers it.
jimh406
Explorer III
May 20, 2021
I use about foot stall mat squares, but also squares of plywood work as well.

Forum Discussion

Recommended jack stand ground support plates.

About Travel Trailer Group

Related Content

Support Trailer

Plate to plate gap

Fifthwheel supports

Slide out support

Slide Supports