The instructions warned me but I screwed up anyways when I mounted the storage brackets for the Stablecampers on my AF 1150. They were right, you don’t want to have to remove these. If you ever put these on learn from my mistake and be sure there isn’t any interference. In my case I should have mounted them further towards the outside of the camper. Where I mounted them they came out right above the rails on the truck bed. I was shy about a half inch, now I get to fix the spots (4) where I removed them. That adhesive is some tough stuff.What would the proper material be to fix these (4) spots? It seems like the paint used is some type of vinyl as it melted pretty easy when I used the heat gun to soften the adhesive.Thanks,Rick

It looks a whole like the liquid water proof membrane used in showers and small decorative ponds. It can be found at tile stores.

second the eternabond tape with a good bit of overlap.

Likely not paint but vinyl laminated to ply, looks like luan.Will some of the original area be covered by new location?Or how far do they need to be moved. Id lean toward using thin material screwed using existing holes, bedded in caulk to cover 'oops'. Aluminum flat bar, 1/8" or better would work. Possibly covering old location extending to beneath new location.

I might try filling the recess with 3M 5200 first.

Repair Help (Sealing) | Good Sam Community

jimh406
Explorer III
Sep 09, 2020
I would paint it with a good paint.
Kayteg1
Explorer II
Sep 09, 2020
I would laminate it with epoxy. You can add color to epoxy.
Per my experience eternabond can actually create problems as you can't see where it did not stick to the surface and it will funnel the water on your structure.
Riley01
Explorer
Sep 09, 2020
I sure do appreciate all of the great suggestions. I think I'll give the Eternabond tape a shot and just keep an eye on it.

Thanks,
Rick
naturist
Nomad
Sep 09, 2020
Plastidip spray?
RickW
Explorer III
Sep 09, 2020
I might try filling the recess with 3M 5200 first.
AnEv942
Nomad
Sep 09, 2020
Likely not paint but vinyl laminated to ply, looks like luan.
Will some of the original area be covered by new location?
Or how far do they need to be moved.
Id lean toward using thin material screwed using existing holes, bedded in caulk to cover 'oops'. Aluminum flat bar, 1/8" or better would work. Possibly covering old location extending to beneath new location.
Buzzcut1
Nomad II
Sep 09, 2020
second the eternabond tape with a good bit of overlap.
jdc1
Explorer II
Sep 09, 2020
It looks a whole like the liquid water proof membrane used in showers and small decorative ponds. It can be found at tile stores.
pianotuna
Nomad III
Sep 09, 2020
I would use Eternabond.

Forum Discussion

Repair Help (Sealing)

About Travel Trailer Group

Related Content

Slideout seal repair

Rv roof repair using Flex seal.

Rear seal repair. Anything else needed?

Need some input on rubber roof repair/sealing

Repairing Wiper Seal on Slideout