Slideout wall fail Lance 1121
Just wanted to expand on a post by Sleepy dated 7/10/2010.. I have a 2002 Lance model 1121.. I didn't realize the side wall was failing when I bought the unit in early 2018.. but by March 2019 it was ...
Forum Discussion
here are some pictures
This is the start of the wall fail.. it got much worse over time!
This is after the sleepy's unistrut install. showing the 1/2" x 3" bolt securing the tension tie to the floor. also notice the c/l marking of the wall.
This is inside looking at the refigerator wall and floor brace installed.. notice how tension tie was cut to allow slide to pass and go under seal plate
This shows the two 5/8" x 2" bolts from the brace through the refigerator wall.
Finished look! no more sag!!
This is the start of the wall fail.. it got much worse over time!
This is after the sleepy's unistrut install. showing the 1/2" x 3" bolt securing the tension tie to the floor. also notice the c/l marking of the wall.
This is inside looking at the refigerator wall and floor brace installed.. notice how tension tie was cut to allow slide to pass and go under seal plate
This shows the two 5/8" x 2" bolts from the brace through the refigerator wall.
Finished look! no more sag!!
