Torklift Super Truss
Anyone see a problem with shortening my 48" extension to 36". Top shank is 2-1/2" solid steel milled down to 2" on the hitch end, 5-3/4" back. Bottom compression tube (hollow) is 2", both with a hitch...
Forum Discussion
"Anyone see a problem with shortening my 48" extension to 36"."
If you go this route, I would do a lot of measuring before cutting to make sure the shortened pieces will still be perfectly parallel and align perfectly with the receivers. Even being off 1/16" or 1/8" could cause some real issues since everything is very ridged with no give.
Good Luck,
BradW
If you go this route, I would do a lot of measuring before cutting to make sure the shortened pieces will still be perfectly parallel and align perfectly with the receivers. Even being off 1/16" or 1/8" could cause some real issues since everything is very ridged with no give.
Good Luck,
BradW
