What did you do to your Camper Today?
After a good washing yesterday I got up early (while the camper is in the shade and the temp has not exceeded 100--yet) to put a good coat of Meguiar's Marine/RV one step Cleaner Wax on. I'm a huge f...
Forum Discussion
The very last sections on the inner tub walls got their insulation and paneling after five years :), and the front wall beneath the cabover finally got its paneling installed over the plywood (All of the original interior walls have finally been paneled!)
The "floor" of the driver's side wing that over hangs the side of the truck got its insulation sheet installed (it's a sandwich of two laminated 5/8" sheets of plywood, a 3/4" sheet of Polyisocanurate foam, and then a sheet of 1/8" lauan plywood), and the 1/8" plywood overlay is going on next, then its time to start running wires and plumbing, and finishing the gas lines, while building in the lower cabinet frame.
Need to do a little microwave shopping before I decide on reusing Mr. KIT's original microwave, as the new microwave cabinet above the rangehood has room for a slightly larger one and the beauty ring is for a microwave larger than what I had in Mr. KIT.
The "floor" of the driver's side wing that over hangs the side of the truck got its insulation sheet installed (it's a sandwich of two laminated 5/8" sheets of plywood, a 3/4" sheet of Polyisocanurate foam, and then a sheet of 1/8" lauan plywood), and the 1/8" plywood overlay is going on next, then its time to start running wires and plumbing, and finishing the gas lines, while building in the lower cabinet frame.
Need to do a little microwave shopping before I decide on reusing Mr. KIT's original microwave, as the new microwave cabinet above the rangehood has room for a slightly larger one and the beauty ring is for a microwave larger than what I had in Mr. KIT.
