What did you do to your Camper Today?
After a good washing yesterday I got up early (while the camper is in the shade and the temp has not exceeded 100--yet) to put a good coat of Meguiar's Marine/RV one step Cleaner Wax on. I'm a huge f...
Forum Discussion
Cabinet door making router bits, router bit for installing the plastic edging strips used in RVs, the 4 port 12volt powered USB Charging faceplate for the rear bed space.
More varnish, wire shelving for the cabinets so I can finish installing the face frames, and corner molding because the stuff for the wall board is too narrow to go around corners cleanly.
Finished tidying up the wiring inside the bottom of the over dinette cabinet to reconnect the outlets on it and add an additional outlet on the circuit to make one available near the rear folding bedroom.
Also installed the wire shelf in the main section of the cabinet and the maple face frame onto the front.
More varnish, wire shelving for the cabinets so I can finish installing the face frames, and corner molding because the stuff for the wall board is too narrow to go around corners cleanly.
Finished tidying up the wiring inside the bottom of the over dinette cabinet to reconnect the outlets on it and add an additional outlet on the circuit to make one available near the rear folding bedroom.
Also installed the wire shelf in the main section of the cabinet and the maple face frame onto the front.
