Avion truck campers - Hundreds of photos
Without going into too much painful detail, we had a mishap several week-ends ago. While working with sand bag crews on the Mississippi River, the truck and camper fell into the flood waters as a road...
Forum Discussion
ticki2 wrote:
Here is my jack extension . If you don't need additional width you can use a simple plate , 2 holes at the top to bolt to the angle bracket on the camper and 2 at the bottom to bolt the jack .
Ticki2.....Awesome, that could be my solution right there. I already have spacer blocks, however they need to be a wee bit wider, at the moment I have to position the front tripod so I can get the rear tire between the legs then lower the camper on the truck then re position the legs again so as to get pass the rear leg of the tripod. With this set up of yours I can add an additional 2" to each side and also add my height.
BTW what kind of metal did you use, and thickness.
Thanks for the solution...one step closer to Muley Point...
Yeh Mon
ps, without the 2x6 spacers my height was ok, so I only need to gain back the 3" I lost.
