So what did you do to your Truck Camper today?
I saw these threads in some of the other Open Roads RV Forums, but didn't see one for TCs. I'll start... I installed Interior LED puck lights and a 12v power outlet.
Forum Discussion
Here are the new legs installed. The front two(4160) were pretty straight forward. 3 locknuts and 3 washers each. The back two (4560) were a little more challenging since the camper has a bumper attached to the same structure. Each one has the same 3 locknuts and washers and an additional bolt that took a little coaxing to get back in.
The job took about 2 hours total. I took my time. Each motor had to be removed and reinstalled on a new leg. They also had to be adjusted because the internal attachment point between the motor and leg did not line up. The motor would not seat down inside the leg. I adjusted each motor by quickly cycling it (while tilted on top of the leg) until they lined up. Once they lined up, the motor slide into place..
The lower bolt that was a little tricky:
Side view with new legs:
Old and new rear (4560):
Close up of differences (4560):
The job took about 2 hours total. I took my time. Each motor had to be removed and reinstalled on a new leg. They also had to be adjusted because the internal attachment point between the motor and leg did not line up. The motor would not seat down inside the leg. I adjusted each motor by quickly cycling it (while tilted on top of the leg) until they lined up. Once they lined up, the motor slide into place..
The lower bolt that was a little tricky:
Side view with new legs:
Old and new rear (4560):
Close up of differences (4560):
