So what did you do to your Truck Camper today?

Installed all new led bulbs, replaced tv (hey it is college football season) and reconfigured power (DC and AC access), cables and installation, added new interior HDTV antenna and have the components to install a new King- Jack exterior HDTV mountable head on current exterior antenna mast,; also added Sirius Sat Radio in place of old radio.

...and.. next week replacing my POS propane generator (total of 145 hrs in 8 years of use and broken constantly) with a new Onan. Hope this one works out better!

Nothing again.. Too hot in Dallas.. Going to the RV show instead!!

I turned on the fridge.
I took the sheets off the bed.
I loaded some clothes.
I wondered why I didn't empty the fresh water tank after the last trip.

Yesterday I washed and waxed the entire rig! It SHINES! (I like shiny.. :) ) Then last night I replaced all the old area rugs, towels, bedding, etc. I had in the Weekender that were in blues with new ones in greens, browns, etc. that I purchased for it to coordinate with the color scheme. I was Mr. decorator! ;)

Dak

Loaded in the fly rods, waders, outdoor clothes, water is full, propane is topped off. I still have food to rustle up, Kayaks to load...looking forward to 9 days on the road. Still have to swap out my 16's for the 19.5s but that will be done by Friday.

Nothing...Too hot in Dallas. Waiting for the cool front to come in this weekend. Also the big RV show this weekend!!

got most of the caulking done,time for some camping.Birch Bay state park this weekend,teachers are on strike here in B.C. so the campgrounds are still busy and the weather is great.

Carb Cleaner wrote:
I hacked up a piece of 1x6 and threw the pieces on a disc sander to make some bumper extensions. This gives me a fat 1/2" at my truck's taillights. After screwing the first version onto the existing bumpers, I realized it would be best if they didn't extend past the top of the rubber bumpers, preventing a snag on my truck's bed rail while loading/unloading the camper. So, I took 'em off and cut/sanded 'em again. I debated about epoxy, and decided against it, for now. The screws are #10x1.25".

Brilliant... this is getting done before our next trip...

I hacked up a piece of 1x6 and threw the pieces on a disc sander to make some bumper extensions. This gives me a fat 1/2" at my truck's taillights. After screwing the first version onto the existing bumpers, I realized it would be best if they didn't extend past the top of the rubber bumpers, preventing a snag on my truck's bed rail while loading/unloading the camper. So, I took 'em off and cut/sanded 'em again. I debated about epoxy, and decided against it, for now. The screws are #10x1.25".

Added an MPPT controller and upgraded all the wiring to 8 ga.