Adhesive for insulation foam board
I am redoing a couple sections of the roof on my Fifth wheel. I removed the membrane of the whole roof. Then I removed the 1/4"plywood and the 2.5" insulation foam from the sections I am replacing,...
Forum Discussion
Thanks for all the replies! I'm in the middle of a busy work week and won't have much time to go through all the comments and the suggestions at the moment. Hopefully this weekend i will find time to go through all the suggestions.
In short: yes it is a sandwich roof, not structurally strong even out of the factory.
I will experiment with foam board samplings and various adhesives and applications before putting it all together.
I won't replace the whole roof, except the membrane. Only the first 4x8 section in the front, and 2x8 section in the rear. Most of the roof is good and best to leave as it is.
Again, thanks for all the responses, i will have more time with a more detailed response after Thanksgiving.
The roof is flat. I believe level in the center, and slopes down toward front and rear.
There are no curved sections in any directions on the roof.
In short: yes it is a sandwich roof, not structurally strong even out of the factory.
I will experiment with foam board samplings and various adhesives and applications before putting it all together.
I won't replace the whole roof, except the membrane. Only the first 4x8 section in the front, and 2x8 section in the rear. Most of the roof is good and best to leave as it is.
Again, thanks for all the responses, i will have more time with a more detailed response after Thanksgiving.
The roof is flat. I believe level in the center, and slopes down toward front and rear.
There are no curved sections in any directions on the roof.
