here is a picture of my LED light strip... Since it finally got warm out , I was able to install and test them..
That is on the brightest setting , with the dimmer , I can drop them all the way down to nothing !
That is on the brightest setting , with the dimmer , I can drop them all the way down to nothing !
Moderator edit to re-size picture to forum limit of 640px maximum width.
I use Viper spray on the sides.. and usually REJEX on the front and rear ..this time I used Meguirers flagship..
Superbright LED's I used the waterproof set-WFLS-NW300-WHT... I used the CPS-12VDC-50 watt power supply...LDRF-8A LED dimmer with remote.. I placed the B1888ANODA Aluminum mount on the side 1/4" below the bottom of the awning , I then placed the LED strip inside that and used the 1548-2m clear lens to cover it all... What a clean look when done... I should have taken a picture in the daylight of the clean install... maybe next week during my next trip..
I left a pigtail of about 12 inches hanging from the one end... I took a piece od double sided Velcro and wrapped it around the awning arm.. Since my awning is manual , I do not have any wires running and my light is almost directly in the middle of the strip. I was not looking to drill a hole so I did it this way . .
