My LED strip pictures
here is a picture of my LED light strip... Since it finally got warm out , I was able to install and test them.. That is on the brightest setting , with the dimmer , I can drop them all the way d...
Forum Discussion
4x4van wrote:
I'm confused; the LED strip is already 12vdc, as is the wiring in your trailer. Why use a 120vac-12vdc power supply? That means you can only use the strip with generator or hookups. When I installed my awning strip LEDs, one of the main points was to use them without genset/hookups. I installed the strip on the roller, and plug in a wire that then runs down the awning arm/leg. From there, it drops under the MH where I ran a short 12vdc line and a plug; out of sight and out of mind. Again, just curious as to why the 120vac power supply?
so far that's the thing I'm having the most trouble with....finding how to power the rf controller. I've found 12v barrel connectors but they say only single color lights. Don't know the barrel size or polarity needed for the controller. My plan is to run it into the basement and pick up power directly from a light in the basement. I could order one with a power supply and cut that connector I guess but I'd really like to not do that. I'd rather wire it up with it's own connector.
