Dicor sealant on my fifth wheel
I know this may sound like a dumb question but does anyone know of a way to save a open tube of dicor sealant without the plastic tube harding up. I only need a patial amount and don't want to waste a...
Forum Discussion
dougrainer wrote:
When you cut the end of the plastic tube, make the cut slightly smaller 3/16 than a 3 inch long threaded 1/4 inch screw. Make sure when you insert this screw, you get the top threads coated in dicor. This will seal the tip area. The 3 inch long screw will stop the hardening process at the plastic tip. When you get ready to use again you just unscrew the threaded screw. It will be tight, but will unscrew. In addition wrap the top end with a plastic bag and seal with duct tape. Doug
I do the 3" screw but then I shove it into a rubber/Nitrile glove finger from the garage and tape that to seal it from air.. works also..
