Forum Discussion

shoots's avatar
shoots
Explorer
Jun 28, 2013

Leveling Toy Hauler For Weight Distribution Hitch

hi all, am trying to level the trailer so we can setup the hitch height for the weight distribution assembly. problem is, we have to raise the front of the hauler to get the inside floor level. we put the leveler to the tongue and the front is higher?

which should we level to get an accurate tongue height measurement? level the tongue or level the inside? confused ....

2008 Fleetwood Redline 19ft Toy Hauler
Toy Haulers
  • Chuck_Gail's avatar
    Chuck_Gail
    Explorer
    Jun 28, 2013
    rrupert wrote:
    Assuming you are sitting on a perfectly flat surface and the frame is straight the whole length of the trailer, measure from the surface up to the frame both front and back and adjust the tongue height until they are both equal.


    Yup, or as much as 1.5" LOWER in the front as measured from front and rear frame to ground.
  • rrupert's avatar
    rrupert
    Explorer
    Jun 28, 2013
    Assuming you are sitting on a perfectly flat surface and the frame is straight the whole length of the trailer, measure from the surface up to the frame both front and back and adjust the tongue height until they are both equal.
  • beemerphile1's avatar
    beemerphile1
    Explorer
    Jun 28, 2013
    I would level the floor since the floor sits directly on the frame.

    I hope your tongue isn't bent.

About Fifth Wheel Group

19,006 PostsLatest Activity: Feb 16, 2025