Circuit breaker Question?
Being a DIY I am terrible with electric 12v systems. Should this circuit breaker have continuity if it is closed? Does it open and reset if there is a short issue?? can they weld themselves open from ...
Forum Discussion
Well this took a bit longer than I wanted but it started raining and rained for several days.
Finally replaced the circuit breaker (it was a 30Amp) and it made no change in the step operation.
With tat being said here is something that has me scratching my head. I had unhooked the motor and jumped the motor to reverse it and the steps went up without even a moan. So I took it for a test run yo get it inspected but had hooked the motor back up. The step stayed in the raised position so I could drive it.
Two blocks from my shop that inspects it for the Missouri inspection the step activates itself and the steps go down.
Now this should never happen with the motor running so now I'm going what the heck. I get out of the MH and the steps stay down no matter what position my switch is in. I start the engine and they stay down.
So now I am wondering what told them to go down??? Kind of weird to me!!!
Any suggestions???
Thanks much Dennis
Finally replaced the circuit breaker (it was a 30Amp) and it made no change in the step operation.
With tat being said here is something that has me scratching my head. I had unhooked the motor and jumped the motor to reverse it and the steps went up without even a moan. So I took it for a test run yo get it inspected but had hooked the motor back up. The step stayed in the raised position so I could drive it.
Two blocks from my shop that inspects it for the Missouri inspection the step activates itself and the steps go down.
Now this should never happen with the motor running so now I'm going what the heck. I get out of the MH and the steps stay down no matter what position my switch is in. I start the engine and they stay down.
So now I am wondering what told them to go down??? Kind of weird to me!!!
Any suggestions???
Thanks much Dennis
