cancel
Showing results for 
Search instead for 
Did you mean: 

Ford v10 stalling in the first five minutes

ocean_bound
Explorer II
Explorer II
I have a 2006 Georgetown Ford V 10 Lately when I start it Then head out It will stall in the first five or 10 minutes when I come to a stop sign Or light And restarts with no problem and does not do it after that Any idea what it could be And it runs perfect after that
Allen&carrie 2006 georgetown XL359 37ft
17 REPLIES 17

atsrmf
Explorer
Explorer
Plugged fuel intake at the gas tank

ocean_bound
Explorer II
Explorer II
Thanks for all the help and ideas I will start with the MAF Cleaning and go from there
Allen&carrie 2006 georgetown XL359 37ft

carringb
Explorer
Explorer
2006 will be throttle-by-wire. The throttle body in them occasionally gets gummed up from PVC vapors, and can cause some stiction. But usually the first symptom of this is throttle lag at low throttle positions. The throttle-by-wire V10s do not have an IAC. Cleaning the MAF regularly is always a good idea.
2000 Ford E450 V10 VAN! 450,000+ miles
2014 ORV really big trailer
2015 Ford Focus ST

theoldwizard1
Explorer
Explorer
Some of this depends on if this is the older mechanical throttle body with a separate Idle Air Control (IAC) valve or the newer electronic throttle body ("throttle by wire")

Cleaning a throttle body is a waste of time. The software is designed to handle "sludged" throttle bodies as long as the plate still moves. (I wrote some of that.)

IAC issues usually results in crank-no start (flooded).

Cleaning the MAF can't hurt.

My gut says it is a fuel pressure issue, but the only way to know for sure is to connect a fuel pressure gauge and drive it while watching the pressure.

theoldwizard1
Explorer
Explorer
wanderingaimlessly wrote:
theoldwizard1 wrote:
crawford wrote:
why not go to any parts houses most do free scans see what it says no guessing

Pre OBD-II

I thought OBD was mandatory since the mid to late 90's. I know I have used mine on Auto's and light trucks back to that era.

Correct ! I mis-read 2006 as 1996 ! Time for new glasses.

carringb
Explorer
Explorer
ocean bound wrote:
I have a 2006 Georgetown Ford V 10 Lately when I start it Then head out It will stall in the first five or 10 minutes when I come to a stop sign Or light And restarts with no problem and does not do it after that Any idea what it could be And it runs perfect after that


Check for "Pending Codes". The fault causing this might not be severe enough to trigger the SES light.

Two items that I would suspect, based on timing.

1) Evap purge valve might be sticking open, pulling too much vacuum on the fuel system. This may cause an intermittent P0452 code, but it only seems to trigger that code occasionally, even when the problem is continuous.

2) Heater on the forward O2 sensors might not be heating up anymore, so it's still over-fueling as it warms up. I've had this issue a couple of time. They only seem to last about 125,000 miles. Eventually it will cause a heater-open-circuit code but it has to get really bad before that happens. Earlier symptoms are what you describe, and may be accompanied by a pending P0133 or P0134 code (O2 sensor slow response).

Sometimes it's easier to diagnose by letting it get worse, although it's never a bad practice to make sure all your scheduled maintenance is up to date.
2000 Ford E450 V10 VAN! 450,000+ miles
2014 ORV really big trailer
2015 Ford Focus ST

carringb
Explorer
Explorer
theoldwizard1 wrote:
crawford wrote:
why not go to any parts houses most do free scans see what it says no guessing

Pre OBD-II


OBD-II has been standard on the E450 since '97.
2000 Ford E450 V10 VAN! 450,000+ miles
2014 ORV really big trailer
2015 Ford Focus ST

MountainAir05
Explorer II
Explorer II
I have no wires going to the throttle body so I would say that this is for a newer model year than ours which is a 99. The cleaning of both keep them clean but did not stop the issue. Just a good warm up and it was fine.

patperry2766
Explorer II
Explorer II
Try cleaning the mass air flow sensor and throttle body, then reset the throttle body calibration. Most likely it is the throttle body, but at least try a cheap $10 fix first to see if it solves the problem.
ALso probably wouldn't hurt to run some Seafoam in the gas every few thousand miles just to keep the system clean.
calibration

throttle body cleaning

MAF cleaning
Courage is the feeling you have right before you fully understand the situation

ocean_bound
Explorer II
Explorer II
Thanks everybody for the information I have a scan gauge up to it and it never throws any kind of code Throttlebody does make sense or mass airflow sensor maybe
Allen&carrie 2006 georgetown XL359 37ft

Home_Skillet
Explorer II
Explorer II
I'm willing to bet it's the throttle body.
Mine was doing the same thing.

I was a Ford Technician for 25 years. I've replaced a ton of throttle bodies.
2005 Gulf Stream Conquest 31ft
BigFoot Levelers,TST in tire TPMS,Bilstein Shocks,Trans temp guage,Lowrace iWAY

MountainAir05
Explorer II
Explorer II
Our 99 does it only in the cooler weather. I just let it warm up and slowly get up to speed and its fine. Never figure out why it does it and never a code.

camperdave
Explorer
Explorer
My van does that sometimes (1998 V10). Seems to be only after sitting for a while, I kind of think it may have to do with the evaporative emissions stuff but that's just a guess. I'm ODB2, but it never throws a code. I also have a 5 star tuner installed (love it), so not sure that's a solution either lol.
2004 Fleetwood Tioga 29v

Yankee_Clipper
Explorer
Explorer
It may be time to flash the PROM. 5-Star Tuning may have the solution.
Yankee Clipper
2014 Winnebago Sightseer 33C on Ford F53 6.8l V10
2014 Honda CRV 4 down toad/Roadmaster Falcon2 with EvenBrake
TireMinder TPMS,Tiger, the Little Big Man minidachshund,
Rosey the minidachshund resident Princess-in-Chief