Full wall slide lock arm frozen in place

Thank you very much for your helpful and timely response. Disassembled and have the part on order!

Thanks again, Doug

Could be out of time. Run slide in and hit reset on board. Might be two reset buttons. Hit the one closest to out side edge.

The motors on these locks wear out eventually. Had to replace one of mine a couple years ago, it’s a pretty easy fix. If you look in the area of the lock you will find an access panel, usually in a cabinet. Remove the panel to get access to the motor. Here’s a link to the part that I installed. Includes a video.

http://www.hwh.com/roomlocks3.html