Help -slides will not extend

try engaging the parking break on the MH. our slides will not extend unless that brake is on. if the brake is engaged then release it and re-engage it.

If the keys are in the ignition as mine were .. slides would not extend. Reason was when the key is in the ignition, when turning off the engine it's sort of sloppy and was slightly turned toward accessory. It was the wife who figured out our dilemma.

Check grounds

I had a 2010 Four winds 25c, If the motor was running the slider wouldn't come out.

You can also ask on the Fleetwood owners forum, I'll sure someone has your year and model rig. http://www.irv2.com/forums/f107/

In your rear outside electrical compartment(the one where the inverter is located) is a fuse panel. Check to see the fuse labeled safety ignition is not blown. It is a three amp fuse.

Our Discovery did that more than once. If your excursion is the same, the control board for each slide is about 4" x 8" and is located on the wall facing you in the bay that has the fuse box and converter. Ours is right behind drivers side rear wheel. On the board will be a small fuse, sometimes clear glass, sometimes white ceramic. Pencil diameter about 1 1/2" long. Should be a 20/240 I think. You can get them at radio shack or napa.

What type of system . . . . Power Gear, HWH, etc

No -no noise at all ??

Do you hear the motor run for the slides???