Itasca 31ke bedroom TV wall mounting

I did it on my 2014 vista 31ke. Sorry, didn't take pictures. Have to remove the wall panel and add wood bracing. First figure out where your tv bracket needs to be screwed to the wall and mark scew holes. Then remove screws holding wall panel on and remove wall panel. Cut a piece of wood to fit between existing bracing where your bracket screws need to go. Screw on new wood backing and put it all back together. Repeat after realizing wood is wrong place (optional). Took a couple of hours.

Will a electronic stud finder work?

Tried the Winnie folks-- no luck there but they tried hard to figure it out- they had no drawings on that wall segment nor on the location of any possible bracing for a TV.(That was a bit worrisome)

Can't quite figure this one out as I can't feel, sense, locate or determine the adequacy of any factory installed bracing-- if its there? .

Planning on that --was wondering if anyone else had some advice from experiece about the set up

did you ask winnie? they probably will furnish a schematic of the wall and the mounting location.
bumpy