Overhang construction
After narrowing down some small Class C’s that fit most of my requirements online I was finally able to look at them in person. I saw about 5 24 ft C’s and notice one had a full front FG front cap an...
Forum Discussion
Gjac wrote:EMD360 wrote:. Did you actually put eternabond tape over the corner seams of the overhang? How wide a strip did you use?
When I bought a 2003 Itasca in 2009 the advice here was to line any roof seams and marker lights with eternabond. That has held up amazingly well and I don’t think it is leaking although I do have some delamination in various areas of the body. I just updated to a 2018 Minnie Winnie and I’m wondering if I should do the same thing when the weather gets better.
Yes on the rear corners, no on the front. Wish I had though. I used two 2” pieces in the corners. One overlapping the other. I taped inside all the marker lights with pieces cut to fit and used some 4” tape over the seams on the roof.. I taped around all the vents and air conditioner after removing the old caulk. It was easier to remove the metal strip on the back than on the front. I was worried I would not be able to get it back on.
