shower wall

Great thing. I'm fine with the shower, but I ordered a pair just in case

Thanks the washer idea sounds good. What I like about this forum is the reply’s get me to think outside the box. Thanks

dougrainer wrote:
This is what the RV industry uses in white/off white/beige. These are what I use also. Doug

https://www.amazon.com/Hillman-Group-58552-Nylon-8-Pack/dp/B00NUFQ0QU/ref=zg_bs_6909189011_9/146-1267538-2040226?_encoding=UTF8&psc=1&refRID=8C5XJ5PE3NE62G5P1583

That is what we call a Panolam rivet. Can be had off the shelf at the Big Box usually.

dougrainer wrote:
This is what the RV industry uses in white/off white/beige. These are what I use also. Doug

https://www.amazon.com/Hillman-Group-58552-Nylon-8-Pack/dp/B00NUFQ0QU/ref=zg_bs_6909189011_9/146-1267538-2040226?_encoding=UTF8&psc=1&refRID=8C5XJ5PE3NE62G5P1583

Way better than what I suggested.

This is what the RV industry uses in white/off white/beige. These are what I use also. Doug

https://www.amazon.com/Hillman-Group-58552-Nylon-8-Pack/dp/B00NUFQ0QU/ref=zg_bs_6909189011_9/146-1267538-2040226?_encoding=UTF8&psc=1&refRID=8C5XJ5PE3NE62G5P1583

Panolam rivets.....

I’m for Mountain’s fender washer idea.

you can try to seal it back using silicone sealant if you have enough space to put it in. if so put in a small amount and push to wall then pull back , wait a 30 seconds or so and push it back and hold. Do this in as many spots as you can. If not get you some fender washer stainless steel with stainless or brass screws and use them around the top. Ensure you seal each hole with sealant as you go.