Slow filling fresh water

I have not discovered a canister filter of any sort yet, and have looked.

Same here filter in line. If not then add one, or pump it in thru your pump.

Same here filter in line. If not then add one, or pump it in thru your pump.

Does your rig have a canister water filter? If so likely the culprit.

The vent is a hard line from the top that has an elbow to go straight down. It is clear up to the elbow. Not sure how to check or clear past that. But I think that is open. Great suggestion and I was hoping that was it.

I see with some looking that I fill the tank from the bottom. Maybe they are all like that. But that means that I cannot add bleach after there is any water in there, as it pushes back at ya and closes the check valve/backflow preventer. How do the rest of you add bleach for sanitising?

Thanks for the help thus far. We will figure it out eventually.

Sounds like maybe the vent line to the tank is clogged if you have one. I had a similar problem with my TT this past year & found a spider had built one heck of a web in the vent line. It made filling the tank really difficult. Finally took the vent line off, blew out the web & all fixed.

Probably full of crud too. Open it and remove the screen and run a wire down it.

MountainAir05 wrote:
Your selector valve may not be open all the way. slipping on stem.

It feels very positive, and stops right at 90 degrees each way. Good suggestion, but I don't think that is it in this case.

Your selector valve may not be open all the way. slipping on stem.