Thetford TECMA toilet

You can flush with the light on, hold the button for 10 seconds it will flush.. Reconnect the high limit sensor......FLUSH THE Tank 3-4 times....fill to top, stay Inside listening to sound as water rises, dump and fill again......the sensor needs to be cleaned....it happens with these toilets....

Thank you for the info. It works as you instructed, but when I unhooked the high limit switch the light still stays on. Shouldn't the light go off?

Our recently purchased Allure has this electric toilet. We have noticed that it also tends to fill the holding tank more quickly than the manual flush toilets we've had in our other motor homes.

I have wondered if it can be replaced with a non-electric john without major re-work.

smlranger wrote:
Our recently purchased Allure has this electric toilet. We have noticed that it also tends to fill the holding tank more quickly than the manual flush toilets we've had in our other motor homes.

I have wondered if it can be replaced with a non-electric john without major re-work.

Probably not. The reason they install this macerator toilet is because the toilet is NOT located on top the Black tank. They install this toilet because it grinds up and then power flushes the debris downstream to the Black tank. Hence, it does use more water. Doug

senior-cit wrote:
I own a coach with the TECMA electric flush toilet with the water saver. Recently the red sensor indicating a full tank came on. The tank has been emptied, but the light stays on. I disconnected the High limit sensoe behind toilet and light still is on. Can't flush with this red light on. Has anyone had this same problem and any suggestions?

There are 2 glued on tank sensors on the outside of Black tank. They may have come loose. That is why you get the full reading. You also may need to flush and rinse the tank 2 or 3 times to remove any debris on the inside walls of the tank to keep the sensors from reading a false level. Doug

Not sure if it should go off or not....disconnect may throw a fault and cause red light...FLUSH that tank out, clear water should run through the tank.....the sensor will go green again unless it is a control board....I am betting on a dirty sensor....Ranger....do not change to a manual toilet, you will be trading for other problems like flooding, they tend to have sticky valves, foot pedals, etc....and have flooded many RV ,s...

GENECOP wrote:
Not sure if it should go off or not....disconnect may throw a fault and cause red light...FLUSH that tank out, clear water should run through the tank.....the sensor will go green again unless it is a control board....I am betting on a dirty sensor....Ranger....do not change to a manual toilet, you will be trading for other problems like flooding, they tend to have sticky valves, foot pedals, etc....and have flooded many RV ,s...

Know about the flooding. Woke up one morning at 3 am, stepped in soggy wet carpet....WTH! Flush valve on toilet in our Journey stuck barely open, over-filled the bowl, flooded the entire back third of the motorhome. DW had last used the toilet at about midnight so it ran over for hours. Luckily, we did a good job of water extraction and clean up and had no issues.

smlranger wrote:
Our recently purchased Allure has this electric toilet. We have noticed that it also tends to fill the holding tank more quickly than the manual flush toilets we've had in our other motor homes.

I have wondered if it can be replaced with a non-electric john without major re-work.

The electric one is used often due to placement. The non electrics have to be attached over the holding tank. The electric can be mounted anywhere.

You can do a dry flush by pressing both buttons at the same time. You can also calibrate how much water refills in the bowl by holding them for several seconds.

I like my techma, would never go back. It works and it's clean. never had a problem with the sensor, but a good flushing and some regular use should get it working again.

IMHO, the techma and san-i-con are a pair.

I believe the macerator in the toilet helps the san-i-con pump live a long life.

I also like the Tecma, I usually clean mine when we move, I use White Vinegar and Liquid dish soap, with about 5 gal of water, empty when I get hooked back up.
And for the san-a-con, I adapted my sewer connector to fit a 1" flexible hose, purchased from "adventure.net", I have used it exclusively for the past 2yrs without a problem., just takes a little longer to dump the black tank., I might add that we use the Washer and also have a D/W that also drains through that 1" hose., just do a thorough flushing when empty the Black tank. Marvin