akaPedro wrote:
New cable will be zip tied to top of loom(s) running underneath, fore to aft. It will provide some protection. There are/were only two connections: behind monitor and behind camera. It is a 75' cable for a 35' MH.
The actual connectors attached to the wires is often where problems arise. Holes or channels the wire snakes through may not be big enough to allow the connectors to pass through. Now if the camera is near the bottom (license plate camera), that's not so hard, but if it's mounted up high, those connectors could be a deal killer.
I always use blank cable for the running and attach connectors after they have been snaked to their location. This enables me pull the wire through the same original or small drilled holes.
