House Water Pump needs assistance priming

Question

Class A system, 1999 model.The only way I can get the pump to prime is by hooking up a garden hose to my "Sanitize" hookup, run the water very slowly and turn the pump on.  It's my understanding that the system is supposed to self prime and not need this extra step...  Now that we are sanitized and ready to go (Leaving for big trip Mon 7/6), I simply intend to leave the system alone (running/standby) and not lose the prime.  Once I help it prime it works as it should.This is a Fleetwood 40VS and I have read the directions, but the directions are a little foggy on the different valve settings especially for using the on board water supply tank.  When the instructions discuss using the on board water tank, it simply says "turn pump on".  This tells me it should self prime and not need extra help..Any ideas are welcome.  As my username indicates, my profession involves many mechanical tasks, including spraying, pumps etc, but these small systems are still new to me.Thanks for any advice!  We are excited about our first trip next week!

kellem · Answer

I've not heard of a water pump requiring priming before operation.

Does the system have good pressure once primed ?

Hot water bypass valve closed ?

If you have a pump converter kit used for winterizing, ensure that the valve is fully closed.

mleekamp · Answer

When we first got our motorhome, after 20 years of a travel trailer, I was a bit confused on the valving system of motorhomes. In short, trying to winterize my unit, you screw the hose to the inlet, and let the other end in the bottle of pink stuff....problem was, I had the valving in the wrong position (NORMAL) vs (WINTERIZE), where it pulls from the bottle. Bottom line: After 30 mins of trying, I realized I was not getting suction due to valving position.

The pump should self-prime. But, only if your water heater bypass is closed (as kellem said), and your other valving in the correct position.

Usually, there is NORMAL, WINTERIZE, SANITIZE, CITY FILL, and CITY WATER, or similar. You may have a few more/less. As I said, I had my valving pointing to NORMAL, which meant it was trying to pull from the tank, not my bottle. In your case, you may have had valving pointing to something else?

BTW -- When I think of Bushnell, I think KITCHEN COOKED POTATO CHIPS!

enblethen · Answer

Make sure the fill valve is closed/

wnjj · Answer

They can go bad.  The pump in our camper worked fine for several years but now will not prime unless the tank is completely full.  Once I prime it by forcing water into it by blowing into the winterizing tube with water in it, it will hold prime fine.  It doesn’t leak back or run unless water is used.  It otherwise works perfectly.  I’ve cleaned the diaphragm twice and now just have a new pump to install.

harvey51 · Answer

I had to prime the pump after every refill of the fresh water tank. It was easy - a syrup bottle with small cap filled with water, squirt into the hose used to pull antifreeze into the pump.

I got tired of that and went to an RC parts store with my story and the clerk sold me a new diaphragm for less than $10 - haven’t had to prime it again. Easy to install.

Forum Discussion

House Water Pump needs assistance priming

About RV Tips & Tricks

Related Content

Prime Time Crusader ???

prime time

NYE Prime Rib

Water Pump won’t Prime

Art of Manliness: Prime Rib Roast