name sign holders

It is AC and has a 40 foot cord… the pipe is glued to a toilet flange, that can be just staked to the ground with tent spikes, or screwed to a piece of wood for a base..

Jjbirish- What do you use to mount to ground? Is your light solar or plugged in?

I made one from plastic pipe to… no plans needed cut pieces to your needs…

Miles Away wrote:

beemerphile1 wrote:

Tried but can't. Your restrictions are set to only allow people on your buddy list to send PMs.

I put you on the list. Try again.

I sent a PM with my email several days ago. I'm looking forward to seeing your creation.

Can you send me a pic too? I can't pm you because of your settings. Thanks

beemerphile1 wrote:

Miles Away wrote:

beemerphile1 wrote:

Miles Away wrote:
Our Good Sam Chapter (Tennessee Valley Sams) makes and sells them....

Got a picture?

YES, but I can't up-load them on this system. PM me your email address and I will send you one.

Tried but can't. Your restrictions are set to only allow people on your buddy list to send PMs.

I put you on the list. Try again.

Miles Away wrote:

beemerphile1 wrote:

Miles Away wrote:
Our Good Sam Chapter (Tennessee Valley Sams) makes and sells them....

Got a picture?

YES, but I can't up-load them on this system. PM me your email address and I will send you one.

Tried but can't. Your restrictions are set to only allow people on your buddy list to send PMs.

beemerphile1 wrote:

Miles Away wrote:
Our Good Sam Chapter (Tennessee Valley Sams) makes and sells them....

Got a picture?

YES, but I can't up-load them on this system. PM me your email address and I will send you one.

Miles Away wrote:
Our Good Sam Chapter (Tennessee Valley Sams) makes and sells them....

Got a picture?

Our Good Sam Chapter (Tennessee Valley Sams) makes and sells them with profits going to the Wounded Warrior Project. They are reasonably easy to make. Go to Loews or Home Depot and purchase a ten foot 2" PVC pipe, one 2" "T",one 2" cap, a post lantern, (about $20 - $25), and a cheap extension cord. Cut the PVC pipe in half and use the first 5' section as the bottom of the post. Attach the T fitting to the top. Then cut and place a one foot section of pipe in the top and another in the side fittings. Place the PVC pipe cap on the one foot arm and screw two hooks on the bottom, seven inches apart. Cut the female end of the extension cord off and hard wire it to the post light with the included wire nuts, and then mount it to the top of the post. Make sure you drill an exit hole for the wire somewhere on the bottom section of the post before mounting the light. Drive a 4 to 5 foot piece of steel pipe or re-bar into the ground and slip the post over it. Plug in the light and your set. The post can be spray pained any color you like, but you must first scuff the surface and prime it with a plastic spray primer.

If your planning on attending the Tennessee Samboree, we will have some there for sale.