Dometic ac and Onan generator
Ac starts and runs fine on shore power but compressor tries to kick in on gen but can’t in two minutes it’ll try again. Ac start up amps are around 15 amps , running amps 10 or so amps on shore power...
Forum Discussion
I would start by checking all the connections. Inspect, disconnect and re-terminate all the wiring in 120 volt distribution panel and transfer switch. Pay special attention to the neutrals in the back portion of the distribution center. Get some electrical de-oxidation grease. Coat the bare conductors prior to terminating. Look for melted insulation and burnt conductors
Genset is running a little too fast which is causing the higher then normal frequency.
Genset is running a little too fast which is causing the higher then normal frequency.
