GenSet Remote Start Problem
I have an older 4.0 Onan Genset. It was fine until yesterday when it would not start from the dash button like normal. The unit does not turn over like it should, just clicks a little. Yet I can st...
Forum Discussion
YES! We really need the Model Number and Spec Code!
We had an old BFA Spec B, and it used a four (maybe six) wire plug into a connector on the control unit. That would accommodate Start/Stop and an Hour Meter. I had neither, only a momentary DPST switch (center off) that I used for Start and Stop, the spring loaded center position being Run.
And correct, it was simply a remote duplication of the Start/Stop switch on the control unit itself.
We had an old BFA Spec B, and it used a four (maybe six) wire plug into a connector on the control unit. That would accommodate Start/Stop and an Hour Meter. I had neither, only a momentary DPST switch (center off) that I used for Start and Stop, the spring loaded center position being Run.
And correct, it was simply a remote duplication of the Start/Stop switch on the control unit itself.
