Magnetek fuse holder for Model 6415

kgkdlewis wrote:
We have a 1994 Coleman Fleetwood Americana Sequoia. We need a fuse holder for the Magnetek Model 6415 Power Converter in it. Ideas?

This one?






I would dump the whole power center and get a new one from Progressive Dynamics.

http://www.bestconverter.com/PD4045-45-Amp-Inteli-Power-Mighty-Mini-Power-Center

well i do think he is going to have to change over to blade fuses
if he needs to replace the board

Here's an image, magnetek 6400 series fuse holder,
luckily I had one to take a pic of!!!



Available here!
http://www.ralphselectronics.com/ProductDetails.aspx?itemnumber=LIT-348007

i think the one above from best converter is the best choice

better than this one


Blade fuse panel

My idea is pretty basic and dumb. Please post an image of the needed part :)

Maybe (and maybe not) this would be a direct replacement. If not, I'd just look for an appropriate DC fuse panel according to the number of fuses etc. that you have. There are quite a few possibilities out there.

Be aware that at least some of the Magnetek converters of that era have two DC output busses on the fuse panel: one is "filtered" and always connected to the battery, the other is "unfiltered" and connected to either the battery or the converter output depending on whether you're on shore power or not. The converter in such cases also has two separate outputs, one for charging the battery (usually some rudimentary regulation) and one, higher-current one for 12V lights etc. In those cases, the replacement fuse panel(s) need to be similarly split. The one linked above is arranged for the split output.

Moved from Forum Technical Support