Replacing the hydraulic leveling pump?

Freightguy wrote:
A real lot of good info you guys are posting. Thank you for that. I am wondering what I am in for though. I am assuming there is no pressure in the lines and that I can remove them without fluid spraying everywhere, or am I wrong?
I am also assuming that when I remove the valve manifold there wont be any springs or unexpected issues that cause more expense or delay.
Please if you have actually done the job before, what is the step by step process for the best results?

LCI jacks have constant pressure. LCI jacks are Power Extend and Power retract. Doug

A real lot of good info you guys are posting. Thank you for that. I am wondering what I am in for though. I am assuming there is no pressure in the lines and that I can remove them without fluid spraying everywhere, or am I wrong?
I am also assuming that when I remove the valve manifold there wont be any springs or unexpected issues that cause more expense or delay.
Please if you have actually done the job before, what is the step by step process for the best results?

Lippert only supplies the Hydraulic system and hyd parts. Valid supplies the Air suspension and controls. Doug

I have a rebuild pump with new motor. post a pic to see if the same. Or PM me an email address and I can send pic.

NEW MOTOR WESTERN W-8053 08053 MONARCH 2590112 M2590112 M2680100 M2680102

Search this on Ebay. There have been threads where folks have used this motor as replacement. A little googling could save you a bunch of bucks.

Try SurplusCenter.com or NorthernTools.com They may have a pump that will work for less.