Suburban W Heater sol. leaking gas
Let me clear that up. I can fire the gas water heater fine, heats, etc. Thermostat shuts flame off, but sol stays energized? I can unplug ground wire, clicks and gas flow quits. Plug back in, and gas ...
Forum Discussion
IF thermostat functions/shuts off propane then there would be NO Voltage to circuit board cause when t-stat OPENS it cuts DC (+)
Only way for DC power to get to circuit board would be wiring issue/cross wire/short inside junction box on side of WH
Have you measured the voltage?
Measure coming from t-stat (red wire) and measure oing to gas solenoids (brown wire)
Can't see how 120 AC would be suspect....separte junction box, separate wiring runs etc.
Only way for DC power to get to circuit board would be wiring issue/cross wire/short inside junction box on side of WH
Have you measured the voltage?
Measure coming from t-stat (red wire) and measure oing to gas solenoids (brown wire)
Can't see how 120 AC would be suspect....separte junction box, separate wiring runs etc.
