Suburban water heater replacement issue
I will be replacing my suburban sw6de water heater soon,was expecting to just have to unscrew connecters for hot and cold lines by unscrewing,but the factory used pex crimp clamps directly to fitting ...
Forum Discussion
I normally have some weird sense of pride in that I will find a way to get those clamps off and new ones on so it looks factory when I'm done.
But in your case I think StonedPanther has some sage advice. Cut the two PEX pipes where you have easy access and pull out the old water heater and PEX as one.
If needed new PEX and be bought at Home Depot ($4.50 for 10 foot)
a clamp tool is $40 and some clamps about $7 for ten clamps.
But in your case I think StonedPanther has some sage advice. Cut the two PEX pipes where you have easy access and pull out the old water heater and PEX as one.
If needed new PEX and be bought at Home Depot ($4.50 for 10 foot)
a clamp tool is $40 and some clamps about $7 for ten clamps.
