U-channel around dome hatch -Gasket question
Where can I find replacement for worn out spline, cap material around roof vent, at the upper margin, where the lid seals to the base? Windy but I hope it explained what I need. Thanks all in advance.
Forum Discussion
pbitschura wrote:
pbitschura wrote:
The stuff from the hardware store does not stand tall enough to seal around the lid. You were correct sir. I have two sets on the way.IAMICHABOD wrote:
Picked some up from the glass shop. I'll report back.
Have to agree with Chris on this one,tried the hardware stuff and it did not seal right,leaving gaps toward the rear of the lid.
The Ventline seal is made for this application.
Good deal. Listening to what Chris has to say on things has saved me money and a lot of time. He is a Pro.
That was the same problem I had,so I went with the Ventline.
Hope that it all works out for you.:Bpbitschura wrote:
The stuff from the hardware store does not stand tall enough to seal around the lid. You were correct sir. I have two sets on the way.IAMICHABOD wrote:
Picked some up from the glass shop. I'll report back.
Have to agree with Chris on this one,tried the hardware stuff and it did not seal right,leaving gaps toward the rear of the lid.
The Ventline seal is made for this application.IAMICHABOD wrote:
Picked some up from the glass shop. I'll report back.
Have to agree with Chris on this one,tried the hardware stuff and it did not seal right,leaving gaps toward the rear of the lid.
The Ventline seal is made for this application.- Have to agree with Chris on this one,tried the hardware stuff and it did not seal right,leaving gaps toward the rear of the lid.
The Ventline seal is made for this application. - Good luck with that.
westend wrote:
That's what I was looking for.
I bought some at my local True Value hardware store. They sell it by the foot.
Not paying two bucks a foot foor vinyl spline. Thanks.- I bought some at my local True Value hardware store. They sell it by the foot.
- X2 on that from Amazon,I used it when I replaced my vent lids,works really well and is a perfect fit with a little left over.
- Ventline makes a replacement gasket that fits the top edge of the base- http://www.amazon.com/Ventline-BVD0455-01-51-Vinyl-Seal/dp/B007HRN4N4
That's available at many more places- just used Amazon as an example.
